I-Flight Stack Blitz F7 with Blitz 45A ESC

BLITZ F7 Stack (F7 V1.1 + 45A 4in1 ESC)

FC // BLITZ F7 V1,1 Flight Controller

Top Features:

• Improved circuit design, better components and lower electrical noise!
• DJI HD VTX Connector (Plug-and-Play / No soldering required)
• FC indicator LEDs for visual debugging
• With LC filter

Specifications:

• MCU: STM32 F722
• Gyro: BMI270
• Barometer: DPS310
• OSD Chip: AT7456E
• Flash: 32MB (Blackbox flash)
• UARTS: 6
• Motor outputs: 4x (SH1.0 connector)
• I2C serial: SDA / SLA pads
• Smartaudio / IRC Tramp VTX protocol supported
• LED controller: Yes
• Beeper pad: Yes
• Firmware target: IFRC-IFLIGHT_BLITZ_F722
• Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
• Dimensions: 36.5*35 mm
• Weight: 7.8g
• BEC: 5V 2.5A

Wiring suggestion:

• UART 1 for VTX HD / Analog
• UART 2 for a Receiver
• UART 3/4/5 for GPS or other sensors that require a serial port
• UART 6 for ESC Telemetry

Tips:

1. F722 MCU has an inner inverter.
2. SBUS、CRSF、ELRS、IBUS、DSM ETC... can be connected to any unused UART_RX，we suggest you connect to Uart_RX2
3. Frsky SmartPort，Tramp & Smartaudio can be connected to any unused UART_TX，we suggest you connect to Uart_TX1
4. F.port can be connected to any unused UART_TX，we suggest you connect to Uart_TX2

ESC // BLITZ E45 4-IN-1 2-6S 45A ESC

Specification:

• Supports: DShot150/300/600/MultiShot/ OneShot etc.
• Mounting Holes: 30.5*30.5mm/Φ4mm
• Supports 2-6S lipo input
• Telemetry Output: NO
• Target: QH-40 16.7
• Current sensor: Yes
• Constant: 45 Amps
• Current rate: 200
• Burst: 55 Amps
• Weight: 14.7g
• MCU: BB21
• BEC: NO

Package Included:

1 Piece X BLITZ F7 V1.1 FLIGHT CONTROLLER
1 Piece X BLITZ E45S 4-IN-1 45A 2-6S ESC
1 SET X SILICON GROMMETS
1 SET X WIRE HARNESS FOR F7 FLIGHT CONTROLLER