Call Us +27 (0)68 785 1940
Fly Sky Receiver FTR10
ArrayR 995,00
Description
FlySky FTR10 2.4G 10CH AFHDS 3 RC Receiver Support i-BUS/S-BUS/PPM Output Compatible PL18 for RC Drone
FTr10 adopts AFHDS 3, Flysky's third-generation automatic frequency hopping digital system. It uses a double-antenna bidirectional transmission system and is uniquely to save space and output standard PPm i-BUS and s-bus signals.
Specifications:
- Brand Name: FlySky
- Item Name: FTr10 Receiver
- Size: 52 x 28 x 22mm
- Weight: 41g
- RF: 2.4G
- Protocol: AFHDS 3
- Data port: i-BUS/S-BUS/PPM/PWM/URAT
- RSSI: Yes
- Antenna type: Dual antenna (103mm x 2)
- Power input: 3.5v-18V
- PWM channels: Yes
-
Remote control distance: 10km (open and no interference limit distance)
- Update online: Yes
- Temperature: -15-+60
- Humidity: 20% - 95%
- Certification: CE, RCM, FCC ID: N4ZFTR1000
Binding:
- Insert the bind cable into the receivers bind port
- Plug the power cable into any other port, and the receivers LED will start to flash quickly indicating that it has entered bind mode
- Put the transmitter into bind mode; (See the transmitters instruction manual for more information)
- Binding is successful when the receivers LED will stop flashing
- Remove the power and bind cables from the receiver.
- Reconnect the power cable to the receiver
- Check to make sure that the transmitter and receiver are working as expected, if there are any issues or unexpected operation follow the steps above to bind again.
Attention:
- Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
- Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so may lead to unintended operation or loss of control.
- Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive electrical noise.
- Keep the receiver's antenna at least 1 cm away from conductive materials such as carbon or metal.
- Do not power on the receiver during the setup process to prevent loss of control.
Note:
- Ports used to connect the receiver to the various components.
- SENS: Connects to sensors
- SERVO: Connectsto the i-BUS module for channel expansion and output S-BUS signals.
- CH1-CH10: Connects the servos, poweer supply or other components.
- BIND: For bind cable
- Power: Flight controller power output.
Package Includes:
1 x FTR10 Receiver